Welcome to A. M. Industries

Standard Sheet Size

1500*2000 mm,1500*4000 mm,1500*1500mm,

1500*4500 mm,1500*3000 mm,2000*3000 mm

Thickness

0.25 mm to 3.00 mm(For Non-Metallic Range),

0.80 mm to 3.00 mm(For Metallic Range)

Tolerances Thickness

<1 mm = + 0.10 mm Length+50 mm

>1 mm = + 0.10 % Width+50 mm

All information and recommendations given in this brochure are correct to the best of our knowledge. Since conditions of use are beyond our control,the information provided can only serve as a guideline.Users must satisfy themselves that products are suitable for the intended processes and uses.We reserve the right to change product design and properties without notice.
Should you have any doubts about choice of gasket material,please refer to us.Our Engineering Cell will be happy to assist you.
Graphite Coating & antistick coasting are available on request.
Properties Applicable for 2.0 mm thick material.

Rolite NAM 30 Steel

Aramid Fibre,Mineral fibre and NBR with Meta Gauge Centre
-Oil resistant
-For medium to higher loadings
-Resistance to water & gases e.g. compressors,pipelines ,gas meters and IC Engines

Rolite NAM 32 Steel

Aramid Fibre,Mineral Fibre and NBR with Metal Gauge Centre
-Higher performance oil resistant
-Excellent thermal,chemical & mechanical properties
-For compressors,pipelines,gas meters and IC engines,pipe unions,pumps,etc.

Density gm/cm3

1.70-2.10

Tensile Strength
a)Acc tp ASTM F 152(Across Grain) N/mm2
b)Acc to DIN 52910 (Across Grain) N/mm2

> 10
> 7

>14
>11

Compressibility ASTM F 36A %

7-15

6-12

Recovery ASTM F 36A %

>50

Fluid Absorption                                            ASTM F 146                         %
         In ASTM Oil NO.3                        AST M F 146                           %
               Increase in Mass
                   Increase in Thickness
         In Fuel B                                               ASTM F 146                           %
            Increase in Mass
                  Increase in Thickness
        In Water / Antifreeze                  ASTM F 146                              %
            Increase in Mass
                  Increase in Thickness
         In Acid (Change in Tensile Strength)
            96% H2SO4+ Acid (49 hrs at 23 c)                                     %
                 95% HNO3 Acid (48 hrs at 23 c)                              %

<10
<8

<10
<7

<15
<5

Ignition Loss DIN 52911 %

<30

Seability Against Nitrogen DIN 3535 Cm3/min

<0.5

Stress Resistance
16h 300 c DIN 52913 N/mm2
16h 175c DIN 52913 N/mm2

25
36 --

25
36

Design Info:M Value
Y Value (mpa)

Max. Peak Temp C

500

510

Max. Continuous Temp C

250

Max. Operating Pressure kg/ cm2

105

160

ASTM F104 Line call-out