| Standard Sheet Size |
| 1500*2000 mm,1500*4000 mm,1500*1500mm,
|
| 1500*4500 mm,1500*3000 mm,2000*3000 mm
|
|
| Thickness |
| 0.25 mm to 3.00 mm(For Non-Metallic Range),
|
| 0.80 mm to 3.00 mm(For Metallic Range)
|
|
| Tolerances Thickness |
| <1 mm = + 0.10 mm Length+50 mm
|
| >1 mm = + 0.10 % Width+50 mm |
|
All information and recommendations given in this brochure are correct to the best of our knowledge. Since conditions of use are beyond our control,the information provided can only serve as a guideline.Users must satisfy themselves that products are suitable for the intended processes and uses.We reserve the right to change product design and properties without notice.
Should you have any doubts about choice of gasket material,please refer to us.Our Engineering Cell will be happy to assist you.
Graphite Coating & antistick coasting are available on request.
Properties Applicable for 2.0 mm thick material.
|
Rolite NAM
33 |
 |
Aramid Fibre,Mineral Fibre and NBR
-Controlled swell properties in oil
-For automotive and chemical industry e.g. IC engine ,hydaulic engines,reiterating
oils and hydrocarbons
-For joints with low sealing pressure e.g. housing valve covers,oil pans etc.
|
|
| Rolite NAM 40 |
 |
Aramid Fibre,Mineral Fibre and NBR Elastomers.
-Certain chemicals have been kept at aminimum level,the excess of which might effect the media.
-It contains ahigh amount of mineral fibre which is bio-soluble & thus do not pose any health hazard.
-It does not contains any material which might contribute to bacterial or fungal growth.
|
|
Fluid Absorption ASTM F 146 %
In ASTM Oil NO.3 AST M F 146 %
Increase in Mass
Increase in Thickness
In Fuel B ASTM F 146 %
Increase in Mass
Increase in Thickness
In Water / Antifreeze ASTM F 146 %
Increase in Mass
Increase in Thickness
In Acid (Change in Tensile Strength)
96% H2SO4+ Acid (49 hrs at 23 c) %
95% HNO3 Acid (48 hrs at 23 c) %
|
10-30
10-30
10-30
10-30
15
5
|
<10
<10
<10
<10
<10
<5
|
